Audi TT virtual cockpit cluster power on

General discussion about interfacing with the CAN bus
Post Reply
crackerx
How the heck did I end up here?
Posts: 1
Joined: 2019 Mar 28 04:02

Audi TT virtual cockpit cluster power on

Post by crackerx » 2019 Apr 04 14:50

Hello

I am trying to power on audi tt 2016 virtual cockpit clustter on table

I need terminal 15 canbus message

I found in some vw mqb datbase


BO_ 960 Klemmen_Status_01: 4 Gateway_MQB
SG_ Klemmen_Status_01_CRC : 0|8@1+ (1,0) [0|255] "" Airbag_MQB,BMS_MQB,Motor_Diesel_MQB,Motor_Hybrid_MQB,Motor_Otto_MQB
SG_ Klemmen_Status_01_BZ : 8|4@1+ (1,0) [0|15] "" Airbag_MQB,BMS_MQB,Motor_Diesel_MQB,Motor_Hybrid_MQB,Motor_Otto_MQB
SG_ ZAS_Kl_S : 16|1@1+ (1,0) [0|1] "" Vector__XXX
SG_ ZAS_Kl_15 : 17|1@1+ (1,0) [0|1] "" Airbag_MQB,BMS_MQB,Motor_Diesel_MQB,Motor_Hybrid_MQB,Motor_Otto_MQB
SG_ ZAS_Kl_X : 18|1@1+ (1,0) [0|1] "" Vector__XXX
SG_ ZAS_Kl_50 : 19|1@1+ (1,0) [0|1] "" Vector__XXX

960 dec is 0x3c0 id of gateway

I send can message id 0x3c0 ff ff ff ff ff ff ff ff

I know is incorrect and i need also crc but with this message cluster wakeup for 40seconds and standby again

Even if i periodic send this messsage same thing

Post Reply