is it possible to emulate oem usb module with adruino?

General discussion about interfacing with the CAN bus
Post Reply
fuzzysig
How the heck did I end up here?
Posts: 5
Joined: 2018 Sep 03 02:36

is it possible to emulate oem usb module with adruino?

Post by fuzzysig » 2018 Sep 03 22:07

im just curious if adruino can be programmed to emulate the oem usb module interface so i can use it to play flac files and actually be able to browse the file/folder like i would normally with oem usb module ( on honda/acura)
im reading about adruino but still dont know what its capabilities are completely

fuzzysig
How the heck did I end up here?
Posts: 5
Joined: 2018 Sep 03 02:36

Re: is it possible to emulate oem usb module with adruino?

Post by fuzzysig » 2018 Sep 06 20:38

honda mid 2000s uses a separate usb module i dont have a picture of it.
all the aftermarket usb modules like grom and usa-spec use either aux or sat radio interface and do a horrible job at integrating the menus and browsing from factory hedunit
so i thought maybe this could emulate the factory usb module and also have oem like browsing + ability to play flac

im completely new to this and only have a very basic idea of what arduino is and R-pi

nemiro
CAN? Tin or aluminum?
Posts: 35
Joined: 2015 Feb 07 20:06

Re: is it possible to emulate oem usb module with adruino?

Post by nemiro » 2018 Sep 10 10:51

You're going to need to take a step back and first get immersed in RPi and/or Arduino before tackling this subject. This is definitely not a beginner's project that you are talking about.

Post Reply