Hello

Introduce yourself here!
Post Reply
brian1e
How the heck did I end up here?
Posts: 1
Joined: 2019 Aug 19 13:33

Hello

Post by brian1e »

I am fairly new to Canbus. The driving force behind my interest is an intermittent DTC (P0522, P0524) low oil pressure. In my '07 Dodge 1500, 5.7l. I would like very much to monitor this value in the ECU and hopefully get to the bottom of this issue. It does not appear to be a valid fault, as there is oil pressure, and the gauge reads normally.

I am desperately seeking the PIDs for the oil pressure parameter. The full set of extended PIDs would be awesome, and allow me to monitor stuff I haven't even thought of yet.

I am still struggling with the different protocols, and modes. Any direction, or instructions would be greatly appreciated.
bcrodick
How the heck did I end up here?
Posts: 7
Joined: 2021 Mar 23 01:21

Re: Hello

Post by bcrodick »

Hello Brian1e,
The CANHack forum is open again, I'm learning but hope to help if you are still interested.
My son-in-law is working on Dodge 1-ton of the same era.
Are you still interested?
Best regards,
Bill
Mechanicsville, VA ( :D Happy coincidence)
Bill
Mechanicsville, VA ( :D Happy coincidence)
"A simple solution is better than a more complex one"
Paraphrase of Willian d' Occam
Post Reply