I am fairly new to Canbus. The driving force behind my interest is an intermittent DTC (P0522, P0524) low oil pressure. In my '07 Dodge 1500, 5.7l. I would like very much to monitor this value in the ECU and hopefully get to the bottom of this issue. It does not appear to be a valid fault, as there is oil pressure, and the gauge reads normally.
I am desperately seeking the PIDs for the oil pressure parameter. The full set of extended PIDs would be awesome, and allow me to monitor stuff I haven't even thought of yet.
I am still struggling with the different protocols, and modes. Any direction, or instructions would be greatly appreciated.
Hello
Re: Hello
Hello Brian1e,
The CANHack forum is open again, I'm learning but hope to help if you are still interested.
My son-in-law is working on Dodge 1-ton of the same era.
Are you still interested?
Best regards,
Bill
Mechanicsville, VA (
Happy coincidence)
The CANHack forum is open again, I'm learning but hope to help if you are still interested.
My son-in-law is working on Dodge 1-ton of the same era.
Are you still interested?
Best regards,
Bill
Mechanicsville, VA (

Bill
Mechanicsville, VA (
Happy coincidence)
"A simple solution is better than a more complex one"
Paraphrase of Willian d' Occam
Mechanicsville, VA (

"A simple solution is better than a more complex one"
Paraphrase of Willian d' Occam