Oil PIDs for 3.6L Pentastar Engines

Ideas and discussion of what to do with the CAN Bus ( i.e. XMDirect, iPod, Carputer, etc... )
Post Reply
How the heck did I end up here?
Posts: 5
Joined: 2013 Nov 29 16:19
Location: Katy, TX

Oil PIDs for 3.6L Pentastar Engines

Post by plextor » 2013 Nov 30 21:12


I noticed from the factory service manual that the 3.6L Pentastar Engine in the 2012+ Wrangler (and other platforms) includes a oil temperature and oil pressure sensor. Has anyone perhaps already discovered the PIDs for these two sensors? I haven't yet done any logging on the CAN diagnostic bus, and wanted to check if anyone had already found these before I spent time on it.


Post Reply