Page 1 of 1

2009 Radio Project

Posted: 2009 Oct 29 09:22
by jim_ee
Trying to use an ELM327 to interface with a radio from a 2009 Sebring[RES]. I am using an ELM327 chip and am having trouble with finding the right CAN bus rate. I have tried 500/250/125/83.33 so far. The 83.33 comes closest to working. Most of the rates just give RTR responses on power up. 83.33 has rx errors etc.

2nd question is - Would it likely be 11 bit headers or possibly 29?

I found the radio connector pinout to be different on this radio [ pin 2 =CAN lo, pin 13 = CAN hi] , traced the schematic out and found the CAN transceiver to be NXP TJA1054 equivalent.

Any suggestions?

Thanks for looking.

Re: 2009 Radio Project

Posted: 2009 Dec 08 22:43
by BCasey
apparently 08 and up LX's ( charger, 300 ) and i think the LC's ( challengers ) are using 125kbaud, not 100% on the serbring but read on here that 125kbaud should work for the newer models.

Re: 2009 Radio Project

Posted: 2009 Dec 09 07:33
by linuxkidd
BCasey is correct. The newer models use 125kbaud for CAN-B now. Also, you should expect 11 bit headers unless they've changed that from the first run as well. I've not done any captures on the 125kbaud CAN-B, so this is just speculation.