SAE Can Standards

General discussion about interfacing with the CAN bus
Post Reply
Blown7
What's hacking?
Posts: 24
Joined: 2007 Apr 22 09:25

SAE Can Standards

Post by Blown7 »

Some standards I recommend


-J2284 - CAN High Speed Interface



-J2411 - Single-Wire Physical Layer



-ISO 11898-1 - CAN



-ISO 11898-4 TTCAN



-ISO 15765 - Diagnostics on CAN (J2480 was abandoned)



-ISO 11992 - Truck and Bus Brake Standard



-J1939 - Truck and Bus Serial Communications Vehicle Network. Uses CAN.



-ISO 11783 - Agriculture and Forestry



-J1978 - OBD II Scan Tool



-J1962 - Diagnostic OBDII Connector found on cars and light trucks.



-J1979 - E/E Diagnostic Test Modes - OBDII modes.



-J2190 - Enhanced E/E Diagnostic Test Modes



-J1850 - Class B Communication Network Interface, GM, Ford and Chrysler.

PWM, VPWM



-J2178 - Class B Communication Network Messages



-ISO 11519-2 Fault Tolerant CAN



-J1708 -Physical layer for older heavy duty truck & bus. See J1587. Being

replaced by J1939.



-J1587 - Upper layer sitting on top of J1708.



-J1699 - CARB test to certify vehicle to OBDII requirements. Open source

software. Sourceforge.org



-J2534 - FLASH programming legislated by CARB.



-ISO 14230 - Keyword 2000



-ISO 9141 - UART based protocol - mostly Europe and Japan. AKA K Line.



-ISO 11519-2 Fault Tolerant CAN



- J2012 OBDII DTCs

- ISO 15031 = J1979
Post Reply