HI Everyone I bought this can bus shield for my arduino uno r3, when it came it had the pins included but not soldered on. I see thatr the canbus shield has 3 pin blocks with 8 pins each and one with 6 pins.
The pins that came with my shield are two 6 pins and two 8 pins. Does anyone know how if I can properly connect these pins? is there pins that can be left blank or do I need to get pin blocks with the proper number pins.
Thank you
Help with Can-bus shield v1.2 pins
-
- How the heck did I end up here?
- Posts: 12
- Joined: 2017 Dec 27 11:39