Activate amplifier with CAN

General discussion about interfacing with the CAN bus
Post Reply
trexyz
How the heck did I end up here?
Posts: 1
Joined: 2017 Feb 07 04:54

Activate amplifier with CAN

Post by trexyz »

Hi there,
I'm new to can-bus hacking and I try to install a custom radio in my '04 300C in use with the stock amp. The problem is that I can't turn the amp on. Does someone know which IDs I'll have to send to switch it on? And does maybe someone know a 12V or 5V source which turns on with ignition but turns off after a few sec I turned off the car?
Sroicomte
How the heck did I end up here?
Posts: 2
Joined: 2017 Apr 07 04:34

Re: Activate amplifier with CAN

Post by Sroicomte »

I tested on my chrysler 300 with no luck, tried also to simulate radio presence by sending canbus radio id.
So far it's a dead end, for the next try i'm going to record a radio start sequence and play that sequence.
Post Reply