CANHack.org

while I dont know the seed key algorithm this info could be very useful. I'll save it and have a look and see if I can find a pattern. one thing is the seeds first value you always have 0x00, is that cause its always 0x00? Also At first glace I noticed that the last hex digit of the second seed valu...

Hey I ended up on here because I was part of lxforums.com and was looking into putting a new head unit in my car but every head unit I came across didnt have all the features I wanted, long story short I also ended up on mp3car.com and wanted to put a pc in my car instead but would only do it if I w...

question: do you have the CDA software, id love to get my hand son it and do some tinkering with my car

apparently 08 and up LX's ( charger, 300 ) and i think the LC's ( challengers ) are using 125kbaud, not 100% on the serbring but read on here that 125kbaud should work for the newer models.

ahh great news!

I havent had much time to look into my problems, altho i figure out the sound issue... the laptop volume was to low HAHA

i know i know... but ill try changing those values to be metric english and see how it goes

thanks again

im not sure but when u figure it out could u post how you solved it or just keep us updated with this. I have a (sorta) similar issue where when i plug in my computer to the can bus network my measurments go from metric to imperial (im in Canada). and i'm wondering if the harness u have (assuming it...

right on, ill take a look at the new tool when im at home. I guess I'm gonna have to double check the wires n everything, pretty sure it was all wired correctly. I might have to debug through it to see whats going on. My evic comes up and changes with teh steering wheel controls n all that, is there...

Hey, I dunno how often you check this site / thread Ryan but I've run into a little problem. well 2 first one is that when I run your code my evic changes from metric to imperial. I'm in Canada so obviously this is a problem for me. I havent really looked into it to far as I just noticed it recently...

ya i had both the D2xx driver and VCP driver and it doesnt worj with both, uninstalled everything then installed just the d2xx and was good to go. havent had a chance to try out ur radio emulator yet, hoping to have some time on saturday afternoon after she gets a good bath. I still gotta solder in ...

ok I got it figured out, it was a driver issue. The driver installation instructions are the best.

getting tons of messages now.

hmm tried to remove the ground while from my harness and still no luck with the terminal or CANHacker that was posted in another thread...

only thing i can think of is either my harness isn't soldered properly or possibly a driver issue...

ill have to sleep on this one

I went and looked at my installation, and I only have the CAN + and CAN - lines hooked up. no ground? Just can+ and can- ?? I have can+, can- and ground. One is a virtual serial port, the other is a FTDI driver that has a different API. According to the documentation, if you have the serial driver,...

heh, im having the same problem. when u first connect it to ur usb port both red and green lights should blink 3 times. I'm getting this far, and then i can open a terminal session and issue it commands and get a response but it wont read anything from my car. I set the bit rate using the command &q...

ya mines flying over the atlantic right now i think lol.

thats probably the same site that I had contacted. I emailed them to see if they had any in stock and they said that they did but their web developer just hasn't update the site yet.